Powtran PI9100 Series Manual page 150

Fault
protection
F8.20
action
selection 4
When "free stop" is selected, the inverter displays Err. *, and directly stops.
When "Stop at the selected mode" is selected, the inverter displays Arr. *, firstly
stops at the selected mode and then displays Err. * When "continue to run" is selected, the
inverter continues to run and displays Arr. *, the operating frequency is set by F8.24.
F8.21
Reserve
F8.22
Reserve
F8.23
Reserve
Continue
running
frequency
F8.24
selection
when failure
happens
Abnormal
F8.25
spare
frequency
When the inverter occurs faults during operation, and the troubleshooting mode for
the fault is set to "continue to run", the inverter displays Arr. *, and runs at the operating
Free stop
Stop at the selected mode
Decelerate to 7% of the rated
frequency of motor and continue
to run, automatically return to the
set frequency to run if the load
drop does not happen.
PID feedback loss when
Ten
running(Fault
thousands
Err.31 )( same as F8.17
digit
units digit)
Too
deviation(Fault
Units digit
Err.42 )( same as F8.17
units digit)
Motor overspeed(Fault
ID Err.43 )( same as
Tens digit
F8.17 units digit)
Initial
Hundreds error(Fault
Err.51 )( same as F8.17
digit
units digit)
Thousands
Reserve
digit
Ten
thousands Reserve
digit
Running at current frequency
Running at set frequency
Running at upper limit frequency
Running at lower limit frequency
Running at abnormal
frequency
60.0% to 100.0%
145
Chapter 5 Function parameter
0
1
2
ID
large speed
ID
position
ID
0
1
2
3
spare
4
☆
00000
☆
0
☆
100