Set Stow And Unstow; With A Push Button Controller; With A Toggle Switch Controller - Will Burt PositionIt PI-35 Operator's Manual

6.1.3 Set Stow and Unstow

This section describes how to set the stow and unstow presets.

6.1.3.1 With a Push Button Controller

With a push button controller:
1. Pan and tilt the positioner until it reaches the desired position.
2. Press and hold the left and right pan buttons simultaneously.
3. With the left and right pan buttons pressed, select "Stow" to set the stow preset position,
or "Unstow" to set the unstow preset position.

6.1.3.2 With a Toggle Switch Controller

If using a controller with toggle switches, a jumper will need to be used to connect the clockwise
and counterclockwise contact closure wires to the contact closure power wire.
With a toggle switch controller:
1. Pan and tilt the positioner until it reaches the desired position.
2. Attach a jumper from both the white (counter clockwise) contact closure wire and green
(clockwise) contact closure wire to the red (power) contact closure wire.
3. Select "Stow" to set the stow preset position, or "Unstow" to set the unstow preset
position.
TP-5406201-B
July 2017
I PI-35
OSITION T
P
6-3