Table of Contents
Advertisement
Section 2
This section describes the installation of the system and provides general procedures that
must be followed to ensure a successful installation.
2.1 Pre-Installation Check
Before installing the system:
•
Be sure to read and understand the entire installation procedure before beginning
installation.
•
Ensure that only a properly trained and qualified certified electrician performs electric
installations and maintenance.
•
All required tools are readily available.
•
That the following warnings are understood and followed:
Mounting Structure Hazard! Before installation, be certain the mounting structure is capable
of resisting forces generated from all loading and environmental conditions including, but not
limited to system size and weight, payload size and weight, sail size, and wind speed.
Mounting the system to a structure unable to resist the forces generated from customer-
specific loading scenario could result in death or serious injury and could damage the
system.
Safety Instruction – Mounting Instructions! Be sure to understand all mounting
instructions. The mounting hardware must include proper means to resist vibration loosening
such as thread-locking compound or locking hardware. Failure to follow mounting
instructions can result in death or injury.
Trained Personnel Only! Only trained and qualified personnel should perform installation,
adjustments, and servicing. Only a properly trained and qualified certified electrician should
perform electric installations and service. Death or serious injury could result if proper
installation, inspection, operation, and maintenance procedures are not observed.
Equipment Damage! Only mount the positioner so that the positioner base faces down. Do
not mount the positioner upside down. Failure to follow mounting instructions can result in
damage to the positioner.
PM-01011-A
October 2023
Installation
I
POSITIONERS
OSITION
T
P
2-1
Advertisement
Table of Contents
Troubleshooting
