Quick Overview - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

1.7 Quick Overview

This section provides a quick overview of the system. Be aware of and follow all associated
precautions when performing these procedures.
To install the positioner (Section 2 ):
1. Mount the positioner with (4) high-strength ⅜ in. or M8 stainless steel bolts and nuts.
See Section 2.5 for additional detail and bolt pattern.
2. Wire the positioner according to the schematic (Section 7). See Section 2.6 for
additional detail.
3. Mount the payload with appropriate hardware. See Section 2.7 for additional detail.
To operate the positioner (Section 3):
1. Attach the controller.
2. Operate the positioner using the controller. See Section 3 for additional detail on the
function of the default joystick controller (P/N: 5098901).
3. If required, see Section 3.3.7 for information on how to use preset positions.
4. If required, see Section 3.3.8 for information on how to adjust the electronic limit
stops. The positioner ships from the factory with electronic limit stops set. There are
no hard stops.
PM-01011-A
October 2023
I POSITIONERS
OSITION T
P
1-9