Lugs - Vertiv NetSure-48 VDC Installation And User Manual

provide this UIN number, along with the configuration number, when ordering so that the new controller will match that of the
original controller shipped with the system. The user manual provided with the controller provides instructions for replacing
and programming the controller. It is important to follow these instructions carefully. The user manual also provides
instructions for saving certain controller files that are created when changes are made to the system after leaving the factory.
These files can be programmed into the replacement controller so it can match the latest saved state of the original
controller.
If the NCU is being ordered as a spare part for any of a group of power plants, the same procedure can be followed. If the
replacement controller's configuration does not match that of the original controller, the original files can be retrieved from
the USB drive shipped with the plant, if available. If the USB drive is not available, contact the factory or technical assistance
center to obtain a copy of the original configuration file (all package) so it can be programmed into the new controller.

4.6 Lugs

Standard Crimp Lugs
DC output leads are connected to the output busbars located on the back of the system as shown in Figure 7.4. Order lugs per
Table 4.1, as required.
Table 4.1 Crimp Lug, Two-Hole, 1/4" Bolt Clearance Hole, 5/8" Centers
Lead Size
14-10 AWG
8 AWG
6 AWG
4 AWG
2 AWG
1/0
2/0
Vertiv™ NetSure™ -48 VDC Bulk Output Rectifier System Installation and User Manual
Part Number
245342300
245390200
245346700
245346800
245346900
245391400
245391500
Proprietary and Confidential © 2022 Vertiv Group Corp. 9