The motherboard provides the following jumpers for you to set the
computer's function. This section will explain how to change your
motherboard's function through the use of jumpers.
VGA Control Jumper: J9
This jumper is used to enable or disable the onboard VGA.
J9
Clear CMOS Jumper: JBAT
There is a CMOS RAM on board that has a power supply from external
battery to keep the data of system configuration. With the CMOS RAM, the
system can automatically boot OS every time it is turned on. If you want to
clear the system configuration, use the JBAT (Clear CMOS Jumper ) to clear
data. Follow the instructions below to clear the data:
JBAT
MSI Reminds You...
You can clear CMOS by shorting 2-3 pin while the system is off.
Then return to 1-2 pin position. Avoid clearing the CMOS while
the system is on; it will damage the mainboard.
Jumpers
Disable VGA
1
Keep CMOS
Hardware Setup
Enable VGA
3
3
1
1
Clear CMOS
2-25