Table of Contents
Advertisement
MS-9156 ATX Server Board
Configure/View SCSI Controller Settings
There are 8 items in the "Configure/View SCSI Controller Settings" screen.
These items display or allow you to change the SCSI controller's settings.
Use the arrow keys to highlight the item and then press <Enter> to select the
value you want in each item or enter each item's sub-menu screen.
Options
SCSI Bus Interface Definitions
SCSI Controller ID ................................... 7
SCSI Controller Parity .............................. Enabled
SCSI Controller Termination ................... Enabled
Additional Options
Boot Device Configuration ...................... Press <Enter>
SCSI Device Configuration ...................... Press <Enter>
Advanced Configuration .......................... Press <Enter>
BIOS Information
Interrupt (IRQ) Channel ........................... 11
I/O Port Address ........................................ B000h, B400h
SCSI Controller ID
The item is used to assign a SCSI ID to the SCSI controller. It is recommended
that you should leave the default setting unchanged. Settings: [0] ~ [15].
SCSI Controller Parity
Use the field to enable or disable SCSI parity error checking function. If any
of your SCSI devices does not support parity checking, disable this function.
While disabling the function, you should disable disconnections for all devices,
as parity checking for the reselection phase is NOT disabled. A non-parity
device's I/O operation will never complete if the reselection fails due to a
parity error.
A-4
AIC-7901 at slot 07, 03:07:00
<F6> -- Reset to SCSI Controller Defaults
SCSI Bus Interface Definitions
Advertisement
Table of Contents
