Table of Contents
Advertisement
MS-9156 ATX Server Board
Display <Ctrl><A> Message During BIOS Initialization
When enabled, the message "Press <Ctrl><A> for SCSISelect(TM) Util-
ity" appears on the screen during bootup. If disabled, the message does
not show up, but you can still press <Ctrl> + <A> key combination to
enter the SCSI BIOS utility. Setting options: [Enabled], [Disabled].
Extended Int 13 Translation for DOS Drives > 1 GByte
The field allows SCSI hard disk drives greater than 1 GB to use a trans-
lation scheme of 255 heads, 63 sectors per track. Setting options: [Enabled],
[Disabled].
POST Display Mode
The field determines how much information about your SCSI controller
and devices appear on the screen during bootup. For the most complete
information, choose [Diagnostic]. For a faster boot, select [Silent]. Set-
ting options: [Verbose], [Silent], [Diagnostic].
SCSI Controller Int 13 Support
The field allows you to enable or disable the support for Int 13h. The
software interrupt "Int 13h" is the interface through which the operating
system or application is able to pass commands to hard disk drives, such
as reading, writing and formatting. Setting options: [Enabled], [Disabled:
NOT scan], [Disabled: scan bus].
Domain Validation
When enabled, these options are available if they are implemented in the
device drivers. However, this option is not supported by the BIOS.
Support Removable Disks Under Int13 as Fixed Disks
When [Boot Only] is selected, only the removable media drive designated
as the boot device will be treated as a hard disk drive. When [All Disks]
is selected, all removable media drives supported by the BIOS are treated
as hard disk drives. If selecting [Disabled], no removable media drive is
treated as a hard disk drive and the removable media drives must be con-
trolled by the OS drivers.
BIOS Support for Bootable CD-ROM
When enabled, the SCSI controller BIOS supports bootable CD-ROM
A-8
Advertisement
Table of Contents
