Table of Contents
Advertisement
Installing the Retention Module
MSI Reminds You...
Mainboard photos shown in this section are for demonstration
of the cooler installation for Socket 604 CPUs only. The ap-
pearance of your mainboard may differ depending on the model
you purchase.
Hardware Setup
1. Locate the four retention mod-
ule holes around the Socket 604
on the mainboard.
2. Align the retention module with
two holes on one side of the
Socket 604.
3. Use a flat-headed screw driver
to press the white push pins into
place.
4. Repeat the same procedures on
the other side of the Socket 604.
2-7
Advertisement
Table of Contents
