MSI E7210 MasterX-FA2R User Manual page 56

MS-9156 ATX Server Board
[Floppy]
[LS120]
[Hard Disk]
[CDROM]
[ZIP100]
[LAN]
[Disabled]
MSI Reminds You...
Available settings for "First/Second/Third Boot Device" vary de-
pending on the bootable devices you have installed. For example, if
you did not install a floppy drive, the setting "Floppy" does not
show up.
Boot Other Device
Setting the option to [Enabled] allows the system to try to boot from other
devices if the system fails to boot from the 1st/2nd/3rd boot device.
Boot Up NumLock Status
This setting is to set the Num Lock status when the system is powered on.
Setting to On will turn on the Num Lock key when the system is powered on.
Setting to Off will allow users to use the arrow keys on the numeric keypad.
Setting options: [On], [Off].
Security Option
This specifies the type of BIOS password protection that is implemented. Set-
tings are described below:
Option
[Setup]
[System]
APIC Mode
This field is used to enable or disable the APIC (Advanced Programmable Inter-
3-10
The system will boot from floppy drive.
The system will boot from LS-120 drive.
The system will boot from the HDD.
The system will boot from the CD-ROM.
The system will boot from ATAPI ZIP drive.
The system will boot from the onboard
10/100 Network drive.
Disable this sequence.
Description
The password prompt appears only when end users try to
run Setup.
A password prompt appears every time when the com-
puter is powered on or when end users try to run Setup.