System Configure Jumper: J6; Bios Flash Jumper: J7 - MSI E7210 MasterX-FA2R User Manual

BIOS Flash Jumper: J7

This jumper is used to protect the BIOS boot block from virus infection.
When locked, the BIOS boot block cannot be accessed, making BIOS update
impossible. When BIOS update is intended, remove the jumper cap to disable
BIOS flash protection.
1
J7

System Configure Jumper: J6

The J6 jumper determines which mode the system will enter while pow-
ered on. Under Normal Mode, the system will enter the assigned OS as usual.
Under Configure Mode, the system will directly enter BIOS setup utility. This
enables you to modify the BIOS configurations. Under Recovery Mode, you
have to insert certain boot disk into the floppy drive before powering on the
system. After powered on, the system will read the boot disk and enter DOS.
This enables you to update the BIOS with a Flash utility if necessary.
1
J6
3
1
E n a b l e B I O S
Flash Protection
3
1
Normal Mode Configure Mode
Hardware Setup
3
1
D i s a b l e B I O S
Flash Protection
3 3
1 1
Recovery Mode
2-27