Table of Contents
Advertisement
Serial ATA RAID 0, 1, 10 Connectors: J10, J11, J12, J13
(Optional)
The mainboard provides optional Serial ATA RAID 0, 1, 10 connectors
supported by Silicon Image SiI 3114 controller.
The SiI 3114 is compliant with the Serial ATA 1.0 specification (150 MB/s
data rates), supporting four independent SATA channels and a 32-bit 33/66MHz
PCI bus. It comes with Silicon Image's robust SATA base and SATARaid software
drivers, which currently support JBOD, RAID 0, RAID 1, and RAID 10 for the
Windows, Linux and Netware operating systems. Incorporating a single Phase
Lock Loop (PLL) architecture supporting all four ports, the SiI 3114 features
integrated Serial ATA Link and PHY logic based on Silicon Image's proven,
high-speed Multi-layer Serial Link (MSL
For more information on Serial ATA RAID 0, 1, 10, please refer to (Silicon
Image SiI 3114) Serial ATA RAID 0, 1, 10 Quick User's Guide.
J11
7
1
Optional Serial ATA cable
MSI Reminds You...
Please do not fold the Serial ATA cable into 90-degree angle.
Otherwise, the loss of data may occur during transmission.
TM
J12
J13
1
1
7
7
J10
1
7
Hardware Setup
) architecture.
J10/J11/J12/J13 Pin Definition
PIN
SIGNAL
PIN
1
GND
2
3
TXN
4
5
RXN
6
7
GND
Take out the dust cover and
connect to the hard disk devices
Connect to J10/J11/J12/J13
SIGNAL
TXP
GND
RXP
2-19
Advertisement
Table of Contents
