Connect A Bits External Clocking Device To The Router; Step 5: Connect Power Cables - Juniper MX204 Quick Start Manual

Step 5: Connect Power Cables

Copyright © 2018, Juniper Networks, Inc.
Plug the other end of the RJ-45 cable into the ToD timing device.
3.
Verify that the LEDs for the
4.
Configure the port. See Configuring Clock Synchronization Interface on MX Series Routers.
5.
Table 5: Time-of-Day Port on the MX204 Router
Callout
13
(See Figure 13 on page 11)

Connect a BITS External Clocking Device to the Router

The router has an external building-integrated timing supply (BITS) port—labeled
the front panel of the router.
To connect the router to a BITS external clocking device:
Attach an electrostatic discharge (ESD) grounding trap on your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of the RJ-45 cable into the internal clock port on the router.
2.
Plug the other end of the RJ-45 cable into the BITS external clocking device.
3.
Verify that the LEDs for the
4.
Configure the port. See Configuring Clock Synchronization Interface on MX Series Routers.
5.
Table 6: BITS Port on the MX204 Router
Callout
3
(See Figure 13 on page 11)
Depending on the configuration, your router uses either AC or DC power supplies. Perform
the appropriate procedures for each power supply in your router. The power supplies are
hot-insertable and are field-replaceable units (FRUs). MX204 supports two power supply
modules. The power supplies install in the rear of the chassis in the slots provided.
Connect a BITS External Clocking Device to the Router
ToD port on the router are lit steadily green.
Label Description
ToD ToD RJ-45 port with LED.
port are lit steadily green.
BITS
Label Description
BITS BITS clock interface port with LED.
BITS —on
15