Communications Speed Settings - Autonics TM Series User Manual

6.5.2

Communications Speed Settings



© Copyright Reserved Autonics Co., Ltd.
+0
+16
+0
+16
If 00 is designated, communications are not performed.
You can set the rate of data transmission.
Group
Option Setting Group
(Communication Setting)
A display LED corresponding to the current bps flashes for 5 seconds (1 second
intervals) when the power supply is initially ON.
LED



Parameter
Bits Per
Second 9600,19200,38400
TM2 Series
PWR
CH1
CH2
AL1
AL2
AL3
AL4
It is required to reset controller's POWER (Power OFF -> Power
ON) after changing communication speed (bps) via port B.
One module communication is allowed for Port A.
Communication speed is fixed to 9600 bps.
Make sure that each module has its own communication
address. If there are overlapping addresses, parameters for
overlapping module cannot be monitored and it may affect the
whole communication speed.
6 Parameter Settings and Functions
Factory
Range
Default
2400, 4800,
9600
BPS (Bits Per
TM4 Series
PWR
CH1
CH2
CH3
CH4
-
-
Unit
bps
Second)
-
2400
4800
9600
19200
38400
-
81