Parameter Initialization - Autonics TM Series User Manual

6.6.5.1 Sensor Error MV.


6.6.6

Parameter Initialization

This option resets all parameters in memory to factory defaults.
(Communication Setting)
© Copyright Reserved Autonics Co., Ltd.





This feature sets control output when a sensor open error occurs. Users can
configure ON/OFF, MV settings, etc.
Ignores MV by ON/OFF control or PID control, and sends out a control value based
on the defined MV.
Preceding
Group
Condition
Heating
(Cooling)
Control
Setting
Group
Heating
and
Cooling
Group
Option Setting Group

If selecting "Yes", all parameters will be initialized and temperature
control will be by factory default.

However, communication parameters are not initialized.
When power is on, or in standard control or heating mode, the
controller outputs 0% if HHHH is displayed and 100% if LLLL is
displayed.
When power is on, or in standard control or cooling mode, the
controller outputs 100% if HHHH is displayed and 0% if LLLL is
displayed.
In heating and cooling mode, when power is on or in standard
control, heating output is 0% and cooling output is 100% if
HHHH is displayed; heating output 100% and cooling output is
0% if LLLL is displayed.
Output priority in manual control: Heating(Cooling)_MV >
Stop_MV > Sensor Error_MV
Output priority in automatic control: Stop_MV > Sensor
Error_MV > Heating(Cooling)_MV
Param
eter
PID
ON/
0.0 (OFF)/100.0 (ON)
OFF
Sensor
Error
-100.0 (Cool) to 100.0
PID
MV
ON/ -100.0 (Cool ON)/0.0
OFF (OFF)/100.0 (Heat ON)
Parameter
Parameter Initialize
6 Parameter Settings and Functions
Factory
Range
Default
0.0 ~ 100.0
(Heat)
Factory
Range
Default
YES/NO
Unit
0.0
%
0.0
Unit
NO -
89