Alarm Output Option Settings - Autonics TM Series User Manual

6 Parameter Settings and Functions
Mode
AL-6
LBA
SBA
HBA
Alarm Setting Group
6.4.3

Alarm Output Option Settings

Select the desired alarm output option mode.
Setting
AL-A
AL-B
AL-C
AL-D
AL-E
AL-F
※1: Alarm Latch: Deactivating Alarm Output in Alarm Latch mode: Turn off the power or
send alarm reset signal.
※2: Standby sequence: This option is applied only if PV is in alarm output ON conditions
when power is supplied. If not, alarm output will be provided from the first alarm condition
same as other alarm operations.
※3: Conditions of repeated Standby sequence: Power ON, Changing SV, Related
Alarm(operation mode, option, setting value), Changing Parameter, Changing STOP
mode to RUN mode.
68
Alarm Output
On if loop break is detected.
On if sensor break is detected.
On if current transformer (CT) detects heater
break.
Group Parameter
Alarm Mode
Mode
If it is an alarm condition, alarm output is ON. Unless an alarm
Standard Alarm
condition, alarm output is OFF.
If it is an alarm condition, alarm output is ON. Before reset the
※ 1
Alarm latch
alarm, an ON condition is latched. (Holding the alarm output)
When power is supplied and it is an alarm condition, alarm
Standby
output does not act. From the second alarm conditions,
※ 2
sequence1
standard alarm acts..
Alarm latch When power is supplied and it is an alarm condition, alarm
and standby output does not act. From the second alarm conditions, alarm
sequence1 latch acts.
When Standby sequence
Standby
output does not act. After deactivate the alarm condition,
sequence2
standard alarm acts.
Alarm latch
When Standby sequence
and standby
condition, alarm output does not act. After deactivate the alarm
sequence2
condition, alarm latch acts..
Description (Factory Default)
Absolute Value Low-limit Alarm

If PV is lower than the absolute value of
temperature, alarm output will be ON.

Alarm absolute value can be set in
AL1.L/AL2.L/AL3.L/AL4.L.
Loop Break Alarm
Sensor Break Alarm
Heater Burnout Alarm
Range Factory Default
Alarm 1, 3 : AL-1
See above table.
Alarm 2, 4 : AL-2
Description
※ 3
and it is an alarm condition, alarm
※ 3
is repeated and it is an alarm
© Copyright Reserved Autonics Co., Ltd.
Unit
-