Table of Contents
Advertisement
Installing the Optional Fan Prior to Unit Installation Into Framing
Diagram 1- panel removal
(Recommended - Part # 761-917)
4. Install fan assembly onto pins on unit fl oor.
Important: 120 Volt AC power is needed for the blower. The
Note: Diagram below shows fan bracket only.
receptacle box will be installed on the right hand side of the unit and
will need to be wired by a qualified electrician prior to fan assembly
being installed. The neutral (wider) slot of the polarized receptacle
should be at the top.
Unit must be grounded at all times. Do not cut the ground
terminal off under any circumstances.
1. Shut the power off.
2. Remove the safety screen and glass door (see unit manual for
details).
3. From the back of the unit - remove 4 screws from the fan access
panel (locations shown below).
5. Fold access panel cover down and secure with 2 screws.
6. Connect red + black wires to fan assembly.
4. Connect red + black fan wires to corresponding red + black wires
on the IFC box as shown
Diagram 3- fan wires
920-133
5. Connect fan ground cable to ground lug (located in lower right
corner of unit). Refer to wiring diagram.
Diagram 2- fan install
Diagram 5- DFC wires
8. Connect fan ground cable to ground lug (located in lower right corner
of unit). Refer to wiring diagram.
Diagram 6- ground wires
6. Install fan assembly onto pins on unit floor.
FAN INSTALL AFTER UNIT INSTALLATION
1. The fan may be installed after the unit has been installed and fi nished.
Ensure the unit is turned off and has cooled to room temperature.
2. Remove the screen and glass door (see unit manual for details).
3. Remove any media already installed (logs, glass, etc.) set aside.
4. Remove the log grate.
5. Remove the burner.
6. Remove the fi rebox fl oor panel (brick or enamel).
7. Secure fan access panel back onto the unit with 4 screws (loca-
tions shown below).
7. Remove screen from light assembly.
1
installation
Grandview
G800EH Gas Fireplace |
®
06.24.19
81
Advertisement
Table of Contents
