Lighting Procedure; Shutdown Procedure - Regency Fireplace Products Grandview G800EH Owners & Installation Manual

Medium dv gas fireplace

page of 104

/ 104
Contents
Table of Contents
Bookmarks

Table of Contents

owner's information

Lighting Procedure

IMPORTANT: The remote control system supplied with this appliance has

several options for starting/operating the appliance using the battery

holder and ON/OFF key on the hand held transmitter.

Prior to operating this appliance, please read the remote control operat-

ing instructions (packaged with remote control) to understand how to

operate this remote control system.

1. Ensure the battery holder switch is in the Remote position and / or wall

mounted battery holder (if equipped) is in the <REMOTE> position.

2. Press and release the ON/OFF button on the remote handheld transmit-

ter (see Diagram 1). An audible beep should be heard from the receiver.

If not using the remote, the unit can also be turned on by sliding the

battery holder switch to the <ON> position (if equipped).

ON/OFF

Button

Remote shown in Manual Mode on Hi

3. After approximately 4 seconds the spark ignition system will spark for

60 seconds to light the pilot.

4. The unit will turn on.

On Demand Pilot (seven day safety timer)

Important information if using the appliance in CPI (continuous pilot mode) only

This appliance is a ProFlame 2 system fitted with the "On Demand" Pilot, a safety feature which will shut down the gas valve completely by extinguishing the

pilot light in the event of a continuous full seven days of inactivity.

This only applies if the CPI (continuous pilot) switch is in the "on" position in your remote control transmitter.

Each time the main burner shuts down, manually or through the call from the thermostat, the seven day timer starts again.

The seven day inactivity timer is controlled within the circuit board. Therefore, if in CPI mode and when the pilot light is extinguished after seven straight days

of inactivity, the CPI setting on the remote control transmitter will remain in the "CPI" (continuous pilot) position. Therefore, all that is required to relight the

pilot would be to press the on/off button on the remote control transmitter from "on" to "off" and back to "on". Once the pilot has re-established operation

will resume as normal. There is no requirement to do anything with the IPI/CPI mode on the remote control transmitter.

If the unit never goes as long as seven full days without a call for heat, the pilot will remain lit until it is manually shut-off.

If the unit is being operated in IPI (intermittent pilot) mode, neither the above instructions nor the seven day timer will apply.

See the instructions in this manual and on the Lighting Instructions plate on the appliance to light or re-light the pilot.

| Grandview

G800EH Gas Fireplace

Diagram 1

Note: The first try for ignition will last approximately 60 seconds. If there

is no flame ignition (rectification) the board will stop sparking for ap-

proximately 35 seconds. After wait time , the board will start second try

for ignition by sparking for approximately 60 seconds. If there is still no

positive ignition the board will go into lock out.