Table of Contents
Advertisement
G800EC/G800C
Brick Panel Installation
Note: Do not install the firebed grate, media, vermiculite, embers,
and logs until the brick panels are installed.
• Brick panels will discolor a little during normal operation. This is
normal and should not be considered a defect.
1. Remove screen and glass door, if installed.
2. Loosen two screws in locations shown below. Slide upper baffle
towards the back wall and then remove from unit.
3. Loosen 2 screws on pilot assembly in locations shown below.
Slide pilot shield towards the back of the unit and remove from
unit.
4. Install back panel carefully. Tilt panel forward from the top and rest
the bottom of the panel on the firebox floor. Tip top back until it also
rests on the firebox back wall.
5. Loosen screws and remove brick clip.
1
2
Item
Part #
Description
1
N/A
Inside Top of Firebox
2
N/A
Panel
3
761-049 Brick Clip
4
904-519 Screw
920-149b
3
4
BRICK PANEL INSTALLATION
6. Install the right side panel—the angled corner should be located
facing the bottom rear of the fireplace when installing.
NOTE: Shorter row of bricks should be positioned at the bottom of
back and side panels.
7. With panel in position, secure it with the brick clip removed in step
5 and retighten screw.
8. Repeat Steps 5-7 on the left side.
9. Slide the bottom panel carefully underneath the burner and
push to the back until it contacts the back panel.
10. Reinstall the upper baffle.
11. Reinstall the pilot shield removed in step 3.
1
installation
05.18.21
Grandview
G800EH Gas Fireplace |
®
67
Advertisement
Table of Contents
