Regency Fireplace Products Grandview G800EH Owners & Installation Manual page 70

installation
LOG SET INSTALLATION
4. Install 2 log support plates onto the burner with 2 screws each
as shown.
Diagram 5—Install Log support plates
Log Support Plates
Diagram 6—Log support plates installed
5. Place Log 1 onto the grate, behind the rear of the burner. Ensure
the left cut out butts against the end of the burner tube and the
right end of the log butts against the curve of the burner. Final
position of the log should be pulled forward and to the right while
contacting the end and curved parts of the burner.
Diagram 7—Log 1 installation
70
| Grandview G800EH Gas Fireplace
®
920-127a
1
Page 2 of 4
6. Install Log 2 on left log support plate. Line up the pins on the
plate with the pin hole on the log.
2
Diagram 8—Install Log 2
7. Install Log 3 on right log support plate. Line up the pins on the
plate with the pin hole on the log.
2
Diagram 9—Install Log 3
8. Install Log 4 diagonally across Log 2. Rest Log 4 in the notch out
on Log 2 as shown.
4
2
Diagram 10—Install Log 4
G800
1
1
3
09.29.22