Table of Contents
Advertisement
G800
Log Set Installation
Read the instructions below carefully and refer to the dia-
grams. If logs are broken do not use the unit until they are
replaced. Broken logs can interfere with the pilot operation.
The G800 log sets, #761-930 for Oak, #761-932 for Birch, contain
the following pieces:
1
Rear Log
2
Middle Left Log
3
Middle Right Log
4
Center Left Cross Log
5
Front Bottom 'Y' Log
6
Left Rear Log
7
Right Cross Log
8
Middle Front
9
Left Log Piece
10
Right Log Piece
11
Left Front Log Piece
12
Right Front Log Piece
Must also purchase (#761-938) Log
Grate and Ember package separately.
The kit contains:
NOTE: Panels (brick, steel, or enamel) must be installed
prior to installing the log set.
1. Carefully remove the logs from the box and unwrap them. The
logs are fragile, handle with care - do not force into position
when installing.
2
4
11
10
Diagram 1—Log ID
Log Grate
3/4" Ginger glass
Vermiculite
Black/White Embers
Log Support Plates
1
3
7
6
8
12
5
9
LOG SET INSTALLATION
2. Install the log grate—secure with 2 screws in locations show below.
Diagram 2—Log Grate Install
3. Install the supplied crystals over the ember lights underneath the
burner as shown. Place vermiculite and embers on top of the glass.
Do not place any media on the burner.
Diagram 3—Install Glass
Diagram 4—Install Vermiculite + Lava
installation
Grandview
G800EH Gas Fireplace |
®
69
Advertisement
Table of Contents
