G800
Crystal Tray Installation
Note: The optional brick, steel, or enamel panels must be installed
prior to the crystal tray.
1. Place the crystal tray over the burner, as shown below.
2. Attach the crystal tray with two screws, one on the middle left
and another on the middle right of the tray, as shown below.
CRYSTAL TRAY INSTALLATION
3. Add 7 lbs of crystal media and spread it across the tray in one
even layer. Important: ensure that at least 50% of the
gas burner porting remains uncovered. Do not cover
the pilot area.
PILOT
BURNER PORTING
4. If using volcanic stones as additional media, add a maximum
of 13, as shown below. Important: Volcanic stones should
not cover any of the gas burner porting or pilot areas.
5. To remove the crystal tray, reverse the steps above.
Grandview
installation
G800EH Gas Fireplace |
73
®