Table of Contents
Advertisement
installation
|
26
OPTIONAL FAN/BLOWER INSTALLATION
OPTIONAL FAN/BLOWER INSTALLATION
Installer: Please record unit serial number here before installing blower—serial number will not be visible after blower
is installed.
______________________________
Serial No.
The fan should only be installed once the unit is in
place in order to prevent any damage to the fan.
1. Remove 2- 5/16" screws from locations shown
below—set aside for installation.
Remove 2 screws from locations shown
2. Slide the fan cassette fully into position.
Line up fan cassette with screw holes.
3. Align screw holes on fan harness bracket with
holes in fan cassette mounting bracket on right
and left sides.
26 | CI2700/HI500 Wood Insert
919-320b
4. Secure using the two (2) 5/16" screws removed
from Step 1.
Secure fan with 2 screws removed in Step 1
5. Remove 7/16" bolts from position shown below.
**See specifi c faceplate installation instructions
for detailed instructions of fan switch assembly.
6. Align preset strain relief bracket to bottom right
corner of the faceplate, secure with 7/16" bolt
removed in Step 5.
Secure preset strain relief
7. Remove the dummy plug from the faceplate
being installed, by removing the 2 screws
along with washers and nuts. Discard dummy
plug, but keep hardware. Install fan switch
assembly with 2 screws, or use washers
and nuts for Cast Faceplate to lower fas-
cia before sliding faceplate into position.
Fan switch assembly
NOTE: Avoid disconnecting wires from switch
during installation.
1
8. Tuck Power Cord to the bottom right hand side
of the faceplate as shown.
Tuck cord to right side of faceplate
Do not turn fan ON until your insert has reached
operating temperature or at least 30 minutes
after starting fi re.
Important:
The blower to this appliance must be turned
off anytime the fuel door is opened. Prior to
turning the blower back on, ensure there are no
embers near the blower which may have fallen
onto the hearth when the fuel door was opened.
Once the fuel door is closed, the blower may
be turned back on.
CI2600
05.02.18
Advertisement
Table of Contents
