Table of Contents
Advertisement
- Position a collecting container be-
neath the oil pan oil drain screw (E).
- Remove the oil drain screw (E) and al-
low the oil to drain completely.
- Reinstall the oil drain screw (E) with a
new seal and tighten properly.
- Fill in the specified quality of oil
through the filler opening (B) on the
engine until the oil level rises to the
correct mark on the dipstick (A).
When fitted with the optional asphalt
A
fume control system, there is a drainage
hose behind the left side flap.
- Place the end of the oil drain port
hose (E1) in the collection container.
- Remove the screw cap with a wrench
and allow the oil to drain completely.
- Replace the screw cap and tighten
properly.
- Refill with oil as described above.
Changing the oil filter:
All filters are accessed via the service
A
flap (F) on the vehicle's centre wall:
- Remove the screws (G) from the inner
side of the frame and remove the serv-
ice flap (F).
- After completing the maintenance
work, reinstall the service flap (F)
properly.
E
E1
G
F
F 55 9
Advertisement
Table of Contents
