Table of Contents
Advertisement
- (2) Left conveyor speed (%) display and adjustment parameters
- (3) Right conveyor speed (%) display and adjustment parameters
- (4) Left auger speed (%) display and adjustment parameters
- (5) Right auger speed (%) display and adjustment parameters
- (6) Nominal tamper speed (n/min) display and adjustment parameters
- (7) Nominal vibration speed (n/min) display and adjustment parameters
Tamper and vibration range depending on screed type.
A
If the settings are not saved, an adjusted parameter remains valid until another
A
course thickness is chosen. This also applies when restarting the vehicle.
D 22 22
1a
1
2
4
6
1b
1c
3
5
7
1d
1e
Advertisement
Table of Contents
