Table of Contents
Advertisement
1.2
Preparation for transportation
- Close the hopper with switch (34)/(35).
- Engage both hopper transport safeguards.
- Lift the screed completely using switch (69), set the crossbeam lock (75).
- Turn the travel drive preselector (15) to zero.
- Activate set-up mode function (68).
- Fully extend the levelling cylinders with switch (61),(63)/(64).
To extend the levelling cylinders, levelling operating mode (126)/(130) must be
A
switched to "MANUAL" on the remote controls.
- Use switch (45)/(46) to adjust the screed to the basic width of the paver finisher.
m
Lift the auger if necessary!
If the engine is started with the drive lever pivoted out, the travel drive is inhibited.
A
To be able to start the travel drive, the drive lever must first be returned to the
centre position.
D 43 17
Advertisement
Table of Contents
