Table of Contents
Advertisement
1.1
Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver finisher (see chapter F).
Check the operating hours counter to determine whether further maintenance work
m
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (13) to the centre position and the travel drive preselector (15)
to minimum.
- Insert the ignition key (11) in position "0".
It is impossible to start the vehicle if an emergency stop button (10) / (120) is depressed.
A
(Error shown on the display)
NOTE
- Press the starter button (12) to start the engine. Run the starter continuously for a
maximum of 30 seconds, then take a break for 2 minutes!
D 43 6
Caution! Possible subsequent damage!
- No additional consumers (light, heater, etc.) may be
switched on when starting.
- Do not switch the consumers on until the engine has
reached a speed of >1000 revs.
Advertisement
Table of Contents
