Table of Contents
Advertisement
- Mount the required extension parts (5).
m
Make sure that the shaft end is clean!
- Push in the telescopic tube (3). When doing so, make sure that the drive of the au-
ger gear (6) is pushed all the way over the shaft end of the auger extension part
and that the auger threads match.
m
Heed the alignment of the gear! All mounted guides and auger segments must be in
line.
A cord which aligns with the screed or the rear panel of the vehicle can be used e.g.
A
to provide assistance during alignment!
- Remove the expansion bolt (2). Then tighten the clamping bolts (1). Finally tighten
the expansion bolt (2) by hand.
m
Before the clamping bolts (1) can be tightened again, the expansion bolt (2) must be
sufficiently turned back!
Otherwise, the telescopic tube cannot be safely clamped and the splined shaft ends
break.
f
When clamped insufficiently, the telescopic tube can slide out of the support tube.
Danger during transportation!
E 13 26
Advertisement
Table of Contents
