Removing And Installing The Rotor; Inserting And Removing Buckets - Hettich ROTO SILENTA 630 RS Operating Instructions Manual

6.2

Removing and installing the rotor

Removing the rotor with a
clamping nut
4
Fig. 28: Rotor installation and
removal
1 Groove
2 Motor shaft
3 Driver
4 Hole
Installing the rotor with a
clamping nut
6.3

Inserting and removing buckets

Inserting buckets
AB5005en_SA
Close the lid and press down gently on the handle strip.
�� The lid locks using a motor.
[Lid] button lights up.
The
'Lid closed' indicator appears.
The
Personnel:
■
Trained user
1. Open the lid.
2. Loosen the rotor clamping nut using the supplied spanner.
�� After passing the working point for lifting the rotor, the rotor
detaches from the cone of the motor shaft (
1
3. Turn the clamping nut until the rotor can be lifted off the motor shaft.
4. Remove the rotor.
2
3
Personnel:
■
Trained user
The lid is open.
1. Clean the motor shaft (
2. Lightly grease the motor shaft (
disinfection instructions' on page 42 .
3. Place the rotor vertically on the motor shaft (
3 ) of the motor shaft must be in the groove ( 1 ) of the
The driver (
rotor. The orientation of the groove is marked on the rotor.
4. Hand-tighten the rotor clamping nut using the supplied spanner.
5. Check that the rotor is firmly seated.
NOTICE
Damage to the device due to imbalances caused by incor-
rect loading of the rotor.
−
Buckets marked with the number of the rotor location may
only be used there.
Buckets marked with a set number may only be used
together.
Rev.: 04 / 11.2023
2 ) and rotor hole ( 4 ).
2 ), see ⮫ Chapter 8.2 'Cleaning and
Load all swing-out rotor locations with the same
buckets.
Operation
2 ).
2 ).
25 / 50