Turning The Projector On Or Off; Logging On To The Projector; Turning The Light Source On Or Off - Christie CP2315-RGB Installation And Setup Manual

Mode
Projector on
Light source on
Standby

Turning the projector on or off

Turn on the projector to display content, or turn off the projector to conserve energy.
To operate the projector, the circuit breakers must be in the ON position. If you are servicing the
projector or removing the protective covers, ensure that the MAIN and UPS circuit breakers are in the off
position.
• In the right toolbar, tap and hold Power.
If the light source is on when turning off the projector, the light source enters a ten-minute
cool-down period automatically.

Logging on to the projector

Log on to the projector to access projector menus.
1. Tap Login.
2. In the User list, select a user name.
3. Enter your password.
4. Tap Login.

Turning the light source on or off

Turn the light source on to display content or view test patterns, turn the light off to extend the life of
the lasers.
• To turn the light source on or off, in the right toolbar, tap and hold Light.
If you turn on the light source when the projector power is off, power is turned on
automatically.
Allow the projector to cool down for 10 minutes after turning it off.
CP2315-RGB Installation and Setup Guide
020-102772-02 Rev. 1 (05-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
™
• CineLife electronics and light engine are on
• Laser optical sub-system (LOS) and thermo-electric cooler (TEC) devices are off
™
• CineLife electronics and light engine are on
• LOS and TEC are on
• Fans run at full speed
™
• CineLife electronics remain on standby with the light engine off
• LOS and TEC are off
• Fans run at reduced speed
Installing and setting up
25