Dmx Control Channels - ETC ColorSource Spot V 1.0 Installation Manual

ETC Installation Guide
ColorSource Spot V1.0
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows
ctL
(Control).
3. Press the Mode button. The display shows the current DMX control
mode.
4. Press the Up button or Down button to change the DMX control
mode. (The currently saved mode is indicated by a decimal point at
the end of the mode name.)
Stn
•
This is the default mode.
dir
•
lime, strobe, and fan).
1ch
•
3200 K White).
rgb
•
5. Press the Mode button to confirm your selection. The display shows
ctL
(Control).
6. Navigate to the
display.
The display will automatically return to the DMX address after 10 seconds
of inactivity, and edits to the DMX control mode will not be saved. This
cancels unsaved changes.
DMX Control Channels
DMX Channel
1
2
3
4
5
6
7
8
DMX Parameter Values below
* See
ColorSource Spot V
: Standard mode (intensity, red, green, blue, strobe, and fan).
: Direct emitter control (intensity, red, green, blue, indigo,
: 1-channel mode controls the intensity of preset 1 (defaults to
: RGB mode (red, green, and blue).
rtn
(Return) option to return to the DMX address
Stn
Standard
Intensity
Red
Green
Blue
Strobe*
Fan*
dir 1ch
Direct 1 Channel
Intensity Intensity
Red
Green
Blue
Indigo
Lime
Strobe*
Fan*
for the DMX values that set these parameters.
Page 7 of 20
rgb
RGB
Red
Green
Blue
ETC