Dmx Control Channels - ETC ColorSource Spot Pearl v1.7 Installation Manual

ETC Installation Guide
ColorSource Spot Pearl v1.7
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of three available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows the
current DMX control mode.
3. Press the Up button or Down button to change the DMX control
mode:
•
•
•
4. Press the Mode button to confirm your selection.
The display will automatically return to the DMX address after 10 seconds of
inactivity, and edits to the DMX control mode will not be saved. This cancels
unsaved changes.
DMX Control Channels
ct
DMX
Channel (Variable Color Temperature)
1
2
3
4
*Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
ColorSource Spot Pearl
ct
: Variable color temperature (intensity or color temperature).
This is the default mode.
dir
: Direct emitter control (intensity, warm white, cool white,
strobe).
1ch
: 1-channel mode controls the intensity of preset 1 (defaults
to 3000 K White).
Intensity
Color temperature
dir
(Direct)
Intensity
Warm white
Cool white
Strobe*
Page 7 of 16
1ch
(1 Channel)
Intensity
ETC