Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot V1.0
Mounting
The ColorSource Spot V ships with a standard yoke for mounting with a
clamp. You can adjust the position of the yoke when necessary for low-
clearance mounting.
Standard yoke position
You can attach a ColorSource Relay to the yoke. See
more information about ColorSource Relay.
Safety Cable
A safety cable (or other approved
safety device) must be attached to the
fixture. Attachment loops are on the
rear of the fixture. Leave as little slack
as possible in the safety cable to
avoid catching the yoke of the fixture.
Connectors
Power: Two powerCON
•
Data (DMX512/RDM): Two five-pin XLR connectors for data in and
•
thru
Note:
terminate the last fixture in line with a 120 Ohm resistor. To
purchase a terminator, please contact ETC customer service and
request part number SGE1507 (XLR terminator).
ColorSource Spot V
The ColorSource Spot V is not self terminating. You must
Low-clearance yoke position
Safety cable
attachment loops
®
®
TRUE1
connectors for power in and thru
Page 5 of 20
etcconnect.com
for
ETC
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorSource Spot V 1.0 and is the answer not in the manual?
Questions and answers