Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot V1.0
Use Wireless Control
Set Up Multiverse Wireless Communication
This section applies only to the ColorSource Spot V fixture with the
optional Multiverse wireless DMX feature.
You can use a City Theatrical Multiverse
configure and control the fixture. For information on using Multiverse
products, see the documentation provided with the products.
Note:
when setting up your wireless system, download the Multiverse
Wireless Setup Information Guide at etcconnect.com.
To use Multiverse wireless communication, configure the Multiverse
settings on the fixture.
1. With the display showing the DMX address, press and hold the Mode
button for 3 seconds. The display shows
2. Press the Up button or Down button until the display shows
(Radio), and then press the Mode button to display the Multiverse
settings.
3. Use the Up button or Down button to navigate to the Multiverse
setting that you want to change (see table that follows). Press the
Mode button to select the setting, use the Up button and Down
button to modify it, and then press the Mode button again to return
to the Multiverse settings. (The currently saved mode is indicated by a
decimal point at the end of the mode name.)
Note:
To disable wireless communication on the fixture, set the
Radio Strength (
4. When you have finished configuring the Multiverse settings, navigate
to the
then navigate to the
address display.
Connection Status
The dot between the second and third digit on the
7-segment display indicates the current status:
On solid: Connected to a transmitter and
•
receiving data
On flashing: Connected to a transmitter, but not receiving data
•
Off: Not connected to a transmitter
•
ColorSource Spot V
For additional guidance and troubleshooting resources
Str
) to Off (
rtn
(Return) option to return to the
rtn
®
transmitting device to wirelessly
ctL
oFF
).
(Return) option to return to the DMX
Page 9 of 20
(Control).
rAd
rAd
(Radio) option, and
001
ETC
Advertisement
Table of Contents
