Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot jr v2.0/v3.0
DMX Control Channels
5ch
DMX
Channel
(5 channel)
1
Intensity
2
Red
3
Green
4
Blue
5
Strobe**
6
*Original ColorSource Spot jr fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
Data Loss Behavior
When DMX data is lost, the fixture does one of the following actions:
If you selected a preset or sequence, that preset or sequence
•
automatically plays.
If no preset or sequence is active in the background, the fixture goes
•
dark and the DMX start address flashes on the user interface.
Lock the User Interface
After you have set up the fixture, you can lock the user interface to prevent
additional changes.
1. Press and hold the Up button and Down button simultaneously for
3 seconds. The display will show
locked.
2. To unlock the user interface, press and hold the Up button and Down
button simultaneously for 3 seconds.
ColorSource Spot jr
dir
1ch
(Direct)
(1 Channel)
Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
Loc
to indicate that the user interface is
Page 7 of 16
rgb
(RGB)
Intensity
Red
Green
Blue
ETC
Advertisement
Table of Contents
