Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot V1.0
Display
Setting
Uni
Universe
id
SHoW ID
SHoW
PAS
Key
Radio
Str
Strength
Signal
qAL
Quality
Signal
SSi
Strength
rtn
Return
Configure Fixtures Using the Set Light App
Download the Set Light app to a smartphone with NFC
functionality, use the app to set fixture parameters, and
then tap the smartphone to the NFC tag on the fixture
to configure it wirelessly—even when the fixture is not
powered on. Or, after you configure the Multiverse
settings on the fixture, use the Set Light app to
configure one fixture or multiple fixtures wirelessly
from a smartphone or tablet.
Visit
etcconnect.com/Apps
information about the Set Light app.
ColorSource Spot V
Values
Description
001 – 999
Set the Universe value.
Set the value of the final three digits of the Show
ID (the prefix "24" is not displayed). For example,
100 – 359
for the SHoW ID 24200, set the value to 200. This
value must match the SHoW ID value on the
Multiverse transmitting device.
Set the SHoW Key value. This value must match
000 – 500
the SHoW Key value on the Multiverse
transmitting device.
Set the value to the minimum level required for
successful communication between transmitters
and fixtures. Excess power output can cause
reflections and can degrade performance.
Off = Turns off power to the Multiverse radio.
Off
Use this setting to disable wireless
•
oFF
(
)
communication on the fixture.
1 – 4
1 = Low
•
2 = Medium
3 = High
4 = Maximum
Display of the signal quality. Values above 50%
are good signal quality, and above 80% are
1 – 100
excellent. This value can be helpful when
troubleshooting wireless performance.
Display of RSSI (Received Signal
Strength indicator) in dBm, ranging from -20
(strongest) to -120 (weakest). (Note that the
-20 – -120
negative symbol does not display on the fixture.)
A display of "---" indicates that there's no
connection.
Return to the
or scan the code for more
Page 10 of 20
rAd
option.
Set Light app
ETC
Advertisement
Table of Contents
