Restore Factory Defaults; Error Codes; Specifications And Reference - ETC ColorSource Spot V 1.0 Installation Manual

ETC Installation Guide
ColorSource Spot V1.0

Restore Factory Defaults

Press and hold the Mode button, Up button, and Down button
simultaneously for 5 seconds. The DMX start address will blink once to
confirm that defaults have been restored.

Error Codes

These error codes may display on the user interface.
CAL
: Screen toggles between
•
with the color calibration. The fixture will need to be returned to the
ETC factory; contact your local dealer to set up a repair.
OtP
: Screen toggles between
•
fixture has gone into over-temperature protection mode to avoid
damaging the fixture. If the error does not clear, contact
ETC Technical Support (visit etcconnect.com/contactETC).
No App
•
upgraded fixtures have a software issue. Reload software to clear
the error. If the error persists, contact ETC Technical Support (visit
etcconnect.com/contactETC).

Specifications and Reference

For current and complete compliance and specifications, see the
ColorSource Spot V datasheet at etcconnect.com.
Environment
Maximum recommended ambient operating temperature: Ta = 40°C
•
(104°F)
Maximum anticipated external surface temperature at 40°C
•
ambient: Tmax = 80°C (176°F)
External temperatures after 5 minutes of full-brightness operation at
•
25°C (77°F) ambient: 30°C (86°F)
External Temperature (steady state achieved) at 25°C (77°F): 37°C
•
(99°F)
Electrical
Operates between 100 V and 240 VAC at a frequency of 50/60 Hz,
•
or at 208 VAC L-L.
Maximum power consumption is 245 W.
•
Up to 7 luminaires (15 A max) may be linked via power thru
•
connector (8 luminaires total per circuit) when used with an
R20 Relay Module or Unison Echo Relay Panel. Consult breaker trip
curves when used with other equipment. Requires power from a
non-dimmable source.
Inrush:
•
120 V: 55 A (first half-cycle)
-
240 V: 59 A (first half-cycle)
-
ColorSource Spot V
: Screen toggles between
CAL Err
and
OtP Err
and
no APP
and
Page 14 of 20
to indicate a problem
to indicate that the
to indicate that the
ETC