Changing The Dmx Control Mode; Dmx Control Channels - ETC ColorSource CYC Installation Manual

ETC Installation Guide
ColorSource CYC v1.6

Changing the DMX control mode

You can set the DMX control mode for the fixture to one of four available
mode options.
1:
2:
3:
4:
The display will automatically return to the DMX address after 10 seconds of
inactivity, and edits to the DMX control mode will not be saved. This cancels
unsaved changes.
Note: Direct mode (

DMX control channels

DMX
Channel
1
2
3
4
5
6
7
ColorSource CYC v1.6
Press any button to wake the display. The display shows the DMX
address.
Press and hold the Mode button for 3 seconds. The display shows the
current DMX control mode.
Press the Up and Down buttons to change the DMX control mode.

• : 5-channel mode (intensity, red, green, blue, and strobe)

• : Direct emitter control (intensity, red, green, blue, indigo,
lime, and strobe)

• : 1-channel mode controls the intensity of preset 1 (defaults to
3200K White)

• : RGB mode (red, green, and blue)
Press the Mode button to confirm your selection.
calibrated mode. As a result, you may see discrepancies
in color between fixtures. ETC recommends operating in
one of the calibrated modes.

(5 Channel)
Intensity
Red
Green
Blue
Strobe

) on the ColorSource CYC is not a

(Direct)
Intensity
Red
Green
Blue
Indigo
Lime
Strobe
Page 6 of 12

(1 Channel)
Intensity

(RGB)
Red
Green
Blue
ETC