Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot V1.0
Re-record Presets
1. Using DMX, set the desired levels for the new preset.
2. Press the Mode button to access the Presets/Sequences menu.
3. Press the Up button or Down button to navigate to the preset number
that you want to re-record.
4. Press and hold the Mode button for 3 seconds to confirm the preset
selection. The user interface will show a 3-second countdown. The
preset number blinks once to confirm that the preset has been
recorded.
Note:
mode (
When you re-record presets with the fixture in RGB mode (
the intensity is set to full and the strobe is turned off.
See
Change the DMX Control Mode on
Adjust the Intensity of Presets
1. Ensure that DMX data is not present.
2. Press the Mode button to access the Presets/Sequences menu, and
then press the Up button or Down button to select the preset that
you want to edit.
3. Press and hold the Mode button for 3 seconds. The display shows
followed by either an intensity level from
4. Press the Up button or Down button to change the intensity level of
the preset in real time.
5. Press the Mode button to confirm your selection and return to
the Presets/Sequences menu. (If you don't press the Mode button,
the display returns to the Presets menu after 10 seconds without
saving your changes.)
ColorSource Spot V
When the fixture is in Direct mode (
1ch
), you cannot re-record presets.
dir
page 7.
0– 99
Page 12 of 20
) or 1-channel
rgb
),
FL
or
for full.
L:
ETC
Advertisement
Table of Contents
