Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot V1.0
Safety
For professional use only. Read the entire manual before using this
equipment.
WARNING:
Risk of eye injury. Do not stare directly into the light.
•
Do not mount the fixture on or near a flammable
•
surface.
When the fixture is mounted, the axis between the
•
yoke attachment points must be parallel to the ground.
Mounting the fixture in a non-parallel orientation risks
property damage or bodily injury.
Disconnect the fixture from power and DMX and allow
•
it to cool before installing accessories or performing
any cleaning and maintenance.
AVERTISSEMENT :
Risque de lésion oculaire. Ne fixez pas directement la
•
lumière.
Ne pas installer le projecteur sur ou à côté d'une
•
surface inflammable.
Lorsque le luminaire est accroché, l'axe entre les points
•
de fixation de la lyre doit être parallèle au sol. Le
montage du luminaire dans une orientation non
parallèle risque de causer des dommages matériels ou
corporels.
Débranchez le projecteur de son alimentation et du
•
DMX et laissez-le refroidir avant d'installer des
accessoires ou d'effectuer un nettoyage ou un
entretien.
WARNING:
Luminaire suitable for use in emergency lighting
applications in accordance with 2017 National Electrical
Code section 700.24 when used with an ETC DMX
Emergency Bypass Controller. Equipment intended for this
purpose must be properly selected, installed, and
maintained so that facility conformance can be obtained.
Installation and servicing shall be performed by qualified
service personnel.
ColorSource Spot V
The ColorSource Spot V is a Directly Controlled
Page 2 of 20
ETC
Advertisement
Table of Contents
