Installing The Imb - Christie CP2415-Xe Installation And Setup Manual

Warning! If not avoided, the following could result in death or serious injury.
•
•
•
Caution! If not avoided, the following could result in minor or moderate injury.
•
a) Remove the tape from the ends of the protective case.
b) Remove the plastic packing material from the lamp.
c) Remove the cathode nut from the lamp before removing it from the case.
d) Hold the anode end of the new lamp in your left hand and angle it up through the hole in
the back of the reflector assembly.
e) Insert your right index and middle finger through the back of the reflector and guide the
lamp onto the cathode clamp. Be careful not to hit the lamp against the reflector.
f) Hand-tighten the cathode nut (E in the image in step 5).
Make sure the smooth portion of the nut is against the cathode clamp.
g) Tighten the cathode screw (D in the image in step 5) with a hex key.
h) On the anode wire (B in the image in step 5), align the ring terminal with the mounting
position on the anode terminal (A in the image in step 5), making sure the crimped side of
the wire is facing out.
i) Fasten in place with the anode screw removed in step 6.
j) Check all leads.
Make sure the anode (+) lead does not touch any projector metal, such as the reflector or
firewall.
8. Close the lamp access door and tighten the two thumbscrews.
9. Close and lock the rear access door.
Make sure the hex key is placed back into its holder before closing the rear access door.

Installing the IMB

Learn how to install the IMB.
1. Release and remove the marriage ring.
The marriage ring is located on the front face of the card cage.
a) Locate the plunger under the security cover on the top-left of the card cage.
b) Pull out the plunger to release the lock.
c) Remove the marriage ring.
2. Install the IMB.
For information on how to install the IMB, refer to the manufacturer's product documentation.
3. Re-install the marriage ring.
CP2415-Xe Installation and Setup Guide
020-103584-02 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
EXPLOSION HAZARD! Handle a lamp by the cathode and anode end shafts only. Do not
handle the lamp by the glass.
EXPLOSION HAZARD! Do not over-tighten the lamp.
EXPLOSION HAZARD! Do not stress the glass of a lamp or bare bulb in any way.
Incorrect lamp power supply and igniter connections can damage the product.
Installation and setup
23