Mounting Procedure Of Componet Communications Unit On Mx2-Series Inverter - Omron CompoNet MX2 Series User Manual

• If the CompoNet Communications Unit is used in the following locations, provide sufficient shielding
measures. Using the CompoNet Communications Unit in any of these locations may result in equip-
ment damage.
Locations subject to static electricity or other forms of noise
Locations subject to strong electromagnetic fields
Locations close to power lines
• During installation, wiring, and network setting on the CompoNet Communications Unit, please refer
to applicable sections of this manual to ensure the correct connection and configuration procedures.
• When removing the CompoNet Communications Unit, do not pull the flat cable.
• When mounting the CompoNet Communications Unit, be sure that the flat cable is not pinched.
• When mounting the CompoNet Communications Unit, be careful about burrs of the break-outs on the
inverter.
2-2-1 Mounting Procedure of CompoNet Communications Unit on
MX2-series Inverter
1
Loosen the screw of the option cover.
Remove the cover.
2
For inverters up to 4.0 kW: Loosen the screws of
the terminal block cover.
This is for the ground terminal wiring.
CompoNet Communications Unit User's Manual (I582-E1)
2 CompoNet Communications Unit Mounting and Wiring
2
2 - 7