How To Remove Componet Communications Unit - Mx2-Series - Omron CompoNet MX2 Series User Manual

6 Troubleshooting
6-6-1

How to Remove CompoNet Communications Unit - MX2-series

When you remove the CompoNet Communications Unit for replacement or inspection, follow the steps
below. For the mounting steps, refer to 2-2 Installation on page 2-6.
1
Loosen the CompoNet Communications Unit
mounting screw.
2
Pull the CompoNet Communications Unit straight
out of the inverter while pushing down on the indi-
cated sides to release the snap-fits.
3
For inverters up to 4.0 kW, loosen the screws of the
terminal block cover to remove the cover.
6 - 14
CompoNet Communications Unit User's Manual (I582-E1)