Rs-232 Interface - Newland NLS-HR3290 User Manual

Enter Setup

RS-232 Interface

When the scanner is connected to the RS-232 port of a Host, scan the RS-232 barcode below to enable
the interface. Moreover, you need to set communication parameters (including baud rate, parity check,
data bit and stop bit) to match the host device.
Default serial communication parameters are listed below. Make sure all parameters match the host
requirements.
Baud Rate
Parity Check
Data Bits
Stop Bits
Hardware Flow Control
** Exit Setup
Parameter
** RS-232
Factory Default
9600
None
8
1
None
14