Multiple Data Formats; Data Format Selection - Newland NLS-HR3290 User Manual

Multiple Data Formats

After the Data Formatter is enabled, you can set the scanner to use one or multiple data formats by
scanning the appropriate barcode below.
Multiple Data Formats Off: Only one data format (default: Format_0) is put into use. To learn how to
switch to another data format, see the "Data Format Selection" section below.
Multiple Data Formats On: The scanner toggles from Format_0 through Format_3 until scanned data
matches the requirements of one data format. If no match is found, the scanner generates an error beep
(if Non-Match Error Beep is turned ON) and the data is not transmitted.
** Multiple Formats Off

Data Format Selection

You can select a data format you want to use by scanning the appropriate barcode below. Note that this
setting is valid only when the Multiple Data Formats feature is turned off.
** Format_0
127
Format_2
Multiple Formats On
Format_1
Format_3
Enter
Setup
** Exit Setup