Enter Setup
Beep on Unknown Character
Due to the differences in keyboard layouts, some characters contained in barcode data may be
unavailable on the selected keyboard. As a result, the scanner fails to transmit the unknown characters.
Scan the appropriate barcode below to enable or disable the emission of beep when an unknown
character is detected.
Beep on Unknown Character
** Do Not Beep on Unknown Character
Inter-Keystroke Delay
This parameter specifies the delay between emulated keystrokes. It is programmable in 5ms increments
from 0ms to 75ms. Single-digit values must have a leading zero. To learn how to set custom delay, see
Appendix 5. The default setting is 10ms.
No Delay
Short Delay (20ms)
Long Delay (40ms)
Custom Delay
23
** Exit Setup