Create A Batch Command - Newland NLS-HR3290 User Manual

Enter Setup

Create a Batch Command

A batch command may contain a number of individual commands each of which is terminated by a
semicolon (;).
Command Structure: Command (+ "=" + Parameter Value)
4 command syntaxes are described as below:
1. Syntax 1: Command
This syntax applies to most configuration situations.
Example:
Set the Baud Rate to 38400bps: 0100060
Enable the Sense Mode: 0302010
2. Syntax 2: Command + "=" + Decimal Digit(s)
This syntax applies to the options/features programming which requires the entry of parameter value
(decimal), such as the Maximum/Minimum Length, Decode Session Timeout, Timeout between
Decodes (Same Barcode) and Sensitivity.
Example:
Set the Decode Session Timeout to 3000ms: 0313000=3000
Set the Sensitivity to (level) 10: 0312040=10
3. Syntax 3: Command + "=" + Hexadecimal Digit(s) (e.g., 0x101A, 0x2C03)
This syntax applies to the features/options programming like the Custom Prefix/Suffix, Terminating
Character Suffix, Code ID Suffix, which requires the entry of parameter value (hexadecimal).
Example:
Set the Terminating Character Suffix to CR/LF: 0310000=0x0D0A
4. Syntax 4: Command + "=" + Double Quotation Marks
For situations where the parameter value is visible character in Syntax 3, this syntax is also
appropriate.
Example:
Set the Custom Prefix to AUTO-ID: 0300000="AUTO-ID"
** Exit Setup 144