Table of Contents
Advertisement
Always comply with the speci cations regarding
the weight of the child restraint system:
In the manufacturer's installation and operat-
R
ing instructions for the child restraint system
used
On a label on the child restraint system, if
R
present
Regularly check that the weight of the child and
child restraint system still complies with the per-
missible gross weight.
When installing a child restraint system, observe
the following:
O Always ensure that the installation area and
the seats are suitable for attaching a child
restraint system.
O Always comply with the manufacturer's
installation and operating instructions for the
child restraint system used.
O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
®When installing an ISOFIX child restraint sys-
tem, also observe the following:
O When using a bab
When using a baby car seat in w
y car seat in weight gr
0/0+ and a rearw
0/0+ and a r
earwar ard-f d-facing c
acing child r
hild res estr traint
system in W
syst
em in Weight gr
eight group I on a r
oup I on a rear seat
ear seat: :
adjust the front seat so that the seat does
not touch the child restraint system.
O When using a f
When using a forw
orwar ard-f d-facing c
acing child r
hild res estr traint
syst
system in W
em in Weight gr
eight group I:
oup I: remove the head
restraint from the respective seat, if possible.
In addition, the backrest on the child
restraint system must lie as at as possible
against the backrest on the vehicle seat.
A er the child restraint system has been
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys-
tems in weight group II or III.
Contact with the roof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
O Ensure that the child restraint system is not
subjected to strain between the roof and the
seat cushion and/or installed facing the
eight group
oup
wrong direction. Where possible, adjust the
aint
seat cushion inclination accordingly.
O Ensure that the child restraint system is not
subjected to strain by the head restraint.
Adjust the head restraints as appropriate.
aint
Occupant safety
57 57
Advertisement
Table of Contents
