Table of Contents
Advertisement
Pull plug
4
with the cable and hose
#
of the tire in ation compressor housing.
Push the plug of hose
5
into ange
#
sealant bottle
1
until the plug engages.
Place tire sealant bottle
1
head downwards
#
into recess
2
of the tire in ation compressor.
Remove the cap from valve
#
tire.
Screw lling hose
8
#
Insert plug
4
into a 12‑V‑socket in your vehi-
#
cle.
5
out
Switch on the vehicle.
#
Press on and o switch
#
6
of tire
compressor.
The tire in ation compressor is switched on.
The tire is in ated. First, tire sealant is pum-
ped into the tire. The pressure may brie y rise
to approximately 500 kPa (5 bar/73 psi).
Do no
Do not switc
t switch h o o t t he tir
during t
dur
ing this phase!
his phase!
Let the tire in ation compressor run for a max-
#
imum of ten minutes.
The tire should then have attained a tire pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tire sealant leaks out, make sure you clean the
a ected area as quickly as possible. It is prefera-
ble to use clean water.
If you get tire sealant on your clothing, have it
7
on the faulty
cleaned as soon as possible with perchloroethy-
lene.
onto valve 7.
If a tire pr
If a tir
e pressur
no not been att
t been attained
Switch o the tire in ation compressor.
#
Unscrew the lling hose from the valve of the
#
3
on the tire in ation
defective tire.
Please note that tire sealant may leak out when
unscrewing the lling hose.
Very slowly drive forwards or reverse approx-
#
imately 33
Breakdown assistance 341
he tire e in ation
in ation com
compr pressor
essor
essure of 200 kP
e of 200 kPa (2.0 bar/29 psi) has
a (2.0 bar/29 psi) has
ained a er
a er t t en minut
en minutes:
es:
(10 m).
341
Advertisement
Table of Contents
