Break-Ln Procedures; Cylinder Identification - Suzuki AN650 2002 Service Manual

BREAK-lN PROCEDURES

During manufacture only the best possible materials are used and all machined parts are finished to a very
high standard but it is still necessary to allow the moving parts to "BREAK-IN" before subjecting the engine
to maximum stresses. The future performance and reliability of the engine depends on the care and restraint
exercised during its early life. The general rules are as follows.
• Keep to these break-in engine speed limits:
Initial 800 km ( 500 miles): Below 4 000 r/min
Up to 1 600 km (1 000 miles): Below 6 000 r/min
Over 1 600 km (1 000 miles): Below 8 500 r/min
• Upon reaching an odometer reading of 1 600 km (1 000 miles) you can subject the motorcycle to full throt-
tle operation. However, do not exceed 8 500 r/min at any time.

CYLINDER IDENTIFICATION

The two cylinders of this engine are identified as No.1 and No.2 cylinder, as counted from left to right (as
viewed by the rider on the seat).
#2 #2
#1 #1
GENERAL INFORMATION 1-7